AirStage ASUB18RLAV 설치 매뉴얼 - 페이지 15
{카테고리_이름} AirStage ASUB18RLAV에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage ASUB18RLAV 17 페이지. Indoor unit (wall mounted type)
AirStage ASUB18RLAV에 대해서도 마찬가지입니다: 운영 매뉴얼 (8 페이지)
페이지 인쇄
Saddle *
Pipe
GOOD
Drain hose
Saddle
Lifted up
] 1
8.2. Installing front cover
Fix the indoor unit
(1) Please remove the spacer.
Indoor Unit
(2) Hook the fi ttings of the indoor unit to the 2 bottom hooks while lowering the unit and
pushing it against the wall.
Indoor unit
Front panel installation.
(1) First, fi t the lower part of the front panel, and insert top and bottom hooks. (Top center
and both sides)
(2) Attach the 6 screws.
(3) Attach the intake grille.
Intake grill installation.
(1) The fi xing axle of the intake grille is installed on the front panel.
(2) Lay down the intake grille.
Outside wall cap *
Sealer putty *
Wall
(Outdoors)
* Field supply
PROHIBITED
End in water
Wave
Spacer
Remove
Top hooks
Bottom hook
Top holes (2 sides)
Top hole (center)
Indoor unit
Top hooks (2 sides)
(4) Close the intake grille.
Panel
Check that:
• The top and bottom hooks are hooked fi rmly and the indoor unit does not move to
the front and rear or left and right.
• The indoor unit is accurately positioned horizontally and vertically.
• When connected from the left rear, the drain hose is at the bottom left of the wall
pipe.
(View from indoor)
Connection cable
(Power supply cable)
Drain hose
Top hook (center)
Top hooks (2 sides)
Intake grille
Wall pipe
Connection pipe
Connection cable
(Transmission and Re-
mote controller cable)
En-14