Draper CD182V2B 사용 설명서 - 페이지 11

{카테고리_이름} Draper CD182V2B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper CD182V2B 20 페이지. 18v cordless rotary drill

페이지 인쇄

BASIC CORDLESS ROTARY DRILL OPERATIONS

8.1 BATTERY CHARGING - FIGS. 1 - 2

To charge the battery pack

from the drill.

To release the battery pack, squeeze the grips

located on either side of the battery casing and

gently pull the battery pack from the housing

(Fig.1).

ii.

Plug the adaptor unit into the charger base and

into a 230V/A.C. 13amp, three pin socket. The

green LED

into the charger as shown (Fig.2) .

iii. Do not force, ensure the battery is inserted

correctly. The red LED

illuminate to show that the battery is charging.

The battery will be fully charged after the 3-5 hour

charging period.

The battery pack can then be removed and the red LED

will extinguish. To refit the battery pack to the drill,

push firmly until the battery pack locates and clips into

place.

WARNING: Do not exceed charging period this could

damage the battery. Overcharging the battery (more

than six hours) could damage the battery cells.

NOTE: The battery was discharged after manufacturing

and will therefore require five to ten charges/discharges

before it reaches its full capacity.

Do not expose either the drill or charger to rain or

water.

8.2 DUST AND SWARF

A correctly fitted dust mask, suitable for the activity and

in accordance to the relevant standard must be worn.

Swarf produced by metal drilling is extremely sharp.

Take precautions when clearing swarf. The burr left on

the hole is also sharp and should be removed with a

suitable tool.

Always wear safety goggles.

WARNING: Drill bit will be hot after use.

8.3 INSTALLING AND REMOVING BITS - FIG. 3

The drill is fitted with a keyless chuck, this means that a

chuck key is not required to secure the drill or

screwdriver bit.

i. Place the drill bit shoulder into the chuck as far as it

will go.

ii. Tighten the chuck firmly.

Note: Short screwdriver bits need only be inserted to the

depth of the hexagon shank before tightening chuck by

hand.

, it must first be removed

will illuminate. Slide the battery

on the charger will now

FIG.1

FIG.2

FIG.3