AirStage ASUB24RLAV 설치 매뉴얼 - 페이지 16
{카테고리_이름} AirStage ASUB24RLAV에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage ASUB24RLAV 17 페이지. Indoor unit (wall mounted type)
AirStage ASUB24RLAV에 대해서도 마찬가지입니다: 운영 매뉴얼 (8 페이지)
페이지 인쇄
9. TEST RUN
] 1
9.1. Test run using PCB (Outdoor unit)
• Refer to the Installation Manual for the outdoor unit if the PCB for the outdoor unit is to
be used for the test run.
] 1
9.2. Test run using remote controller
• Refer to the Installation Manual for the remote controller to perform the test run using
the remote controller.
• When the air conditioner is being test run, the OPERATION and TIMER indicator lamp
fl ash slowly at the same time.
10. CHECK LIST
Pay special attention to the check items below when installing the indoor unit(s). After
] 1
installation is complete, be sure to check the following check items again.
Check items
Has the indoor unit been in-
stalled correctly?
Has there been a check for gas
leaks (refrigerant pipes)?
Has heat insulation work
been completed?
Does water drain eas-
ily from the indoor units?
Is the voltage of the power source
the same as that indicated on
the label on the indoor unit?
Are the wires and pipes all
connected completely?
Is the indoor unit earthed (grounded)?
Is the connection cable the
specifi ed thickness?
Are the inlets and outlets
free of any obstacles?
Does start and stop air con-
ditioner operation by remote
controller or external device?
After installation is completed, has
the proper operation and handling
been explained to the user?
En-15
If not performed correctly
Check box
Vibration, noise,
indoor unit may drop
No cooling, No heating
Water leakage
Water leakage
No operation, heat or burn damage
No operation, heat or burn damage
Short circuit
No operation, heat or burn damage
No cooling, No heating
No operation
11. ERROR CODES
If you use a wired type remote controller, error codes will appear on the remote controller
] 1
display. If you use a wireless remote controller, the lamp on the photodetector unit will
output error codes by way of blinking patterns. See the lamp blinking patterns and error
codes in the table below.
Error display
OPERATOR
TIMER
indicator lamp
indicator lamp
(green)
(orange)
(1)
(2)
(1)
(4)
(1)
(6)
(3)
(1)
(3)
(2)
(4)
(1)
(4)
(2)
(5)
(1)
(5)
(3)
(9)
(15)
Display mode
: 0.5 s ON / 0.5 s OFF
: 0.1 s ON / 0.1 s OFF
( ) : Number of fl ashing
Wired Remote Controller Display
Wired Remote
FILTER
Controller Error
Error contents
indicator
CODE
lamp
(red)
Remote controller
communication
error
Anomalous
network
communications
Parallel
communication
error
Power frequency
error
Model information
error/EEPROM
accession error
Room temperature
thermistor error
Indoor heat
exchanger
temperature
thermistor error
Indoor fan motor
error
Drainage error
Outdoor unit error
Error code