Draper CHD96V 사용 설명서 - 페이지 10
{카테고리_이름} Draper CHD96V에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper CHD96V 13 페이지.
페이지 인쇄CHANGING SPEEDS
To change the speed of the chuck, push the
two-speed gearbox selection switch ✫✌, (fig. 6
and 7) forwards for low speed, or backwards
for high speed.
IMPORTANT: ONLY CHANGE SPEED WHEN
THE MACHINE HAS STOPPED.
TRIGGER
When the trigger is depressed the chuck will
rotate (provided the direction switch is set in
the forward or reverse position). This trigger
switch is electronic which enables the user to
vary the speed continuously in both gears. The
speed varies according to how far the trigger
switch is depressed, the further it is depressed
the faster the chuck will rotate and the lighter
it is depressed, the slower it will rotate.
TORQUE CONTROL
By turning the collar ✬✌, (fig.8) it is possible
to adjust the amount of torque.
In the "twist drill" setting, (fig.8 ), the
drill/screwdriver has full torque.
Settings 1-10 can be used in either gear and
provide a facility for setting the torque to the
required level. For example this means that
repetitive driving of screws of the same size
will be driven into the material to the same
torque, thus giving the same fixing strength, or
in the case of countersunk screws, these will all
be driven to the same depth in the material.
The torque control prevents the heads of small
diameter screws being twisted off when
correctly set.
HOLDING THE DRILL
The drill casing is designed to be held
comfortably in two ways.
1. By the handle, (fig.9).
2. Or, by the in-line support grip (fig.10).
OPERATION cont'd ...
Fig.6.
✫✌
Fig.7.
Fig.8.
Fig.9.
Fig.10.
- 9 -
✬✌
✫✌