Draper STORMFORCE CD108SF 사용 설명서 - 페이지 12

{카테고리_이름} Draper STORMFORCE CD108SF에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper STORMFORCE CD108SF 20 페이지. 10.8v cordless rotary drill - bare

페이지 인쇄

BASIC CORDLESS ROTARY DRILL OPERATIONS

8.6 TORQUE SELECTION CONTROL - FIG. 4

By turning the collar

amount of torque.

Settings 1-20 provide a facility for setting the torque to

the required level. For example, this means that repetitive

driving of screws of the same size will be driven into the

material to the same torque, thus giving the same fixing

strength, or in the case of countersunk screws, these will

all be driven to the same depth in the material.

The torque control prevents the heads of small diameter

screws being twisted off when correctly set.

8.7 TWO SPEED GEAR BOX

Select a low gear (1) (slower rotational speed and higher

torque) for screwdriving.

Use a high gear (2) (faster rotational speed and lower

torque) for drilling holes.

8.8 HOLDING THE DRILL - FIGS. 5 - 6

The drill casing is designed to be held comfortably in two

ways,

1. By the handle.

2. Or by the in-line support grip.

8.9 DRILLING WOOD AND PLASTIC

To prevent splitting around the drill holes on the reverse

side, place a piece of scrap timber under the material to

be drilled.

8.10 DRILLING METAL

Metals such as sheet steel, aluminium and brass may be

drilled. Mark the point to be drilled with a centre punch

to help the drill bit tip to locate. A drop of oil on the area

will aid cutting and help prolong the life of the bit.

8.11 SCREWDRIVING

To prevent slip or damage to the screw head, match the

screwdriver bit to the screw head size. To remove screws,

move the direction switch to the reversing position and

apply pressure to the screw head and depress the trigger

slowly).

Screwdriver bits are a consumable item.

Before drilling check that there are no hidden hazards

such as electrical cables, water or gas pipes running below

the surface by use of a metal/voltage detector.

Do not expose either the drill or charger to rain or water.

Do not overcharge the battery (more than six hours) as

this could damage the battery cells.

it is possible to adjust the

- FIG. 5

FIG.4

FIG.5

FIG.6

FIG.7