Draper 17135 대상 지침 - 페이지 12

{카테고리_이름} Draper 17135에 대한 대상 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 17135 20 페이지. 10.8v cordless ratchet - bare
Draper 17135에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄

BASIC RECIPROCATING SAW OPERATION

9.1 SWITCH AND VARIABLE STROKE

RATE CONTROL - FIG. 5

Your reciprocating saw is equipped with a trigger

switch to turn the saw on and off, and to control

the speed.

To start the saw, press the trigger switch

To stop the saw, release the trigger switch.

To vary the stroke rate, simply increase or

decrease the pressure on the trigger switch.

The tighter the trigger switch is pressed, the

higher the speed.

9.2 GENERAL CUTTING

WARNING: Before use, always check to see that the trigger is actuated properly and returns

to the off position when released.

WARNING: When sawing into walls or floors you may encounter electrical wiring. Sawing

into a "live" wire will cause electric shock. Always check with a metal/voltage detector that

there are no hidden hazards such as electrical cables, water or gas pipes running below the

surface.

Make sure the workpiece is firmly anchored. Clamp the workpiece to prevent slipping or

moving while cutting.

Use the appropriate type and size of blade for the workpiece material and size.

Check for clearance beyond the workpiece so the blade will not impact another surface.

Mark the line of cut clearly. If cutting metal, apply cutting oil on the line.

Depress the trigger switch to start the saw and bring it to maximum desired cutting

stroke rate before applying the blade to the workpiece.

Do not force the tool. Place the shoe firmly on the workpiece while cutting. Use only

enough steady pressure on the blade to keep the saw cutting. Reduce pressure as the

blade comes to the end of the cut.

Cutting stroke rates should vary with the workpiece. Hard materials such as metals

require lower stroke rates, for softer materials use higher stroke rates.

Check wood, chip boards, building materials etc. for foreign objects (nails, screws, etc.)

before sawing and remove them, if necessary.

Position the pivoting footplate onto the surface of the work and saw through the work

applying uniform contact pressure of feed.

If the saw blade jams, switch off the tool immediately. Widen the saw cut with a suitable

tool and pull out the saw blade.

FIG.5