Draper 57855 사용 설명서 - 페이지 7

{카테고리_이름} Draper 57855에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 57855 12 페이지. 110v/240v

OPERATION & USE

Make sure that the mains voltage matches the

voltage stated on the machine's rating plate.

FITTING THE SAW BLADE (Fig.2)

(F)

Switch the machine off and disconnect it from the

(C)

power supply.

Set the base plate to the highest position (maximum

depth of cut).

Open the mobile lower blade guard (A).

Rotate the blade until the hole can be seen below the

(A)

base plate. Insert a suitable pin through the hole and

using the hex key supplied (D), undo and remove

(B)

flange screw (C) and blade flange (B).

(D)

Change the blade ensuring that the arrow on the

Fig.2

blade points in the same rotation as the arrow on the

upper blade guard.

Refit the blade flange (B) and flange screw (C) and

tighten.

Before replacing the new saw blade, make sure that

the contact surfaces of the setting discs are clean.

Saw teeth must be wider than the riving knife (F).

(The arrow printed on the fixed guard of the machine

indicates the cutting direction of the teeth).

IMPORTANT:

When changing or fitting a blade always have the

depth of cut set at maximum.

- 6 -