Draper 65839 사용 설명서 - 페이지 14

{카테고리_이름} Draper 65839에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 65839 20 페이지. 10"

MITRE CUTTING (Fig.21):

This operation is the same as cross cutting except the mitre

is locking at any angle other than 90°.

COMPOUND MITRE CUTTING:

This is a combination of bevel cross cutting and mitre

cutting. It is very infrequently used. Follow the instructions

for both mitre cutting and bevel cross cutting.

CHECKING THE BLADE PARALLELISM

(Fig.22):

This check should be carried out before each use

and adjusted if necessary

Ensure the saw is switched off and the plug is

removed from the power supply. Using a steel

ruler (Draper Stock No.12614), measure the

distance ✪✌ and the distance ✫✌. If the two

distances differ, the blade is not completely

parallel and requires adjusting.

ADJUSTING THE BLADE PARALLELISM

(Fig.23):

This can be quite a confined adjustment. If

difficulty is encountered, have a qualified Draper

repair agent carry out the work.

Loosen ✬✌, ✭✌, ✮✌, ✯✌ and ✰✌ screws and

nuts. Adjust the blade and remeasure once all the

fixings have been secured.

When complete and before carrying out any test

cuts, ensure all the fixings are tight.

CUTTING OPERATIONS

MAINTENANCE

✬✌

✭✌

✯✌

- 13 -

Fig.21.

Fig.22.

✪✌

✫✌

Fig.23.

✮✌

✰✌