Draper BS355A 사용 설명서 - 페이지 10
{카테고리_이름} Draper BS355A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper BS355A 20 페이지. 360mm bandsaw
페이지 인쇄
- 1. General Information
- 2. Table of Contents
- 3. Contents/Declaration
- 4. Specification/Guarantee
- 5. Power Supply
- 6. General Safety Instructions
- 7. Additional Safety Rules
- 8. Unpacking and Checking Contents
- 9. Getting to Know Your Bandsaw
- 10. Assembly
- 11. Operation and Use
- 12. Operation and Use
- 13. Tips on Using Your Bandsaw
- 14. Tips on Using Your Bandsaw
- 15. Maintenance/Optional Accessories
ON/OFF SWITCH
When key is in the off/locked position, it
will prevent unauthorized operation of
the bandsaw (Fig.6).
The bandsaw is fitted with a no volt
switch. In the event of a power supply
failure the bandsaw will have to be
manually re-started (Fig.7).
CHANGING SPEEDS
1. Turn the main power switch off and
disconnect from the power supply.
2. Remove the front cover.
3. Refer to Fig.8. and check which pulley
steps to use for the desired speed
and adjust as required.
4. Change the belt on the motor pulley
or drive wheel will allow you to move
it from a larger diameter step to a
smaller step.
5. Replace the front cover.
OPERATION & USE
Fig.6.
Fig.7.
Fig.8.
DRIVE WHEEL
- 9 -
MOTOR PULLEY