Draper MBS46A 사용 설명서 - 페이지 8

{카테고리_이름} Draper MBS46A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper MBS46A 16 페이지. Horizontal and vertical metal cutting bandsaw

4. BELT ADJUSTMENT (Fig.5)

Before any operation involving the belts

can be carried out make sure the power

supply is disconnected. The bolt ✴✌

must be turned anti-clockwise to give

enough movement on the motor so that

the belt can be fitted/adjusted.

* Note: The gearbox oil should be

checked annually. Remove the 4 screws

and plate to gain access to the gearbox.

If it requires topping up use GP80

gearbox oil.

5. BLADE SPEEDS (Fig.6.)

Refer to the material cutting chart (on

page 8) to decide the speed relevant to

the material to be cut. Select the

belt/pulley combination. When set,

tighten the motor tension using bolt ✴✌.

6. NO-VOLT ON/OFF SWITCH (Fig.7)

The saw is fitted with a no volt type

on/off switch. The head is fitted with a

safety catch ✵✌ that when properly

adjusted will automatically switch the

machine off after each cut.

OPERATION & USE

✴✌

✍✌

FIG.5.

FIG.6.

FIG.7.

✵✌

- 7 -