Draper DA50/190 사용 설명서 - 페이지 7
{카테고리_이름} Draper DA50/190에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper DA50/190 16 페이지. 25 & 50 litre compressors
페이지 인쇄
POSITIONING:
Do not stand the compressor on any surface
with a 15° or greater tilt as this will lead to
possible running problems.
Allow a minimum gap of 50cm around the
compressor to aid connection and airflow.
In addition to pneumatic air tools, your
compressor may be connected to several
accessories suitable for blowing, washing
and spraying for example.
For technical specifications and detailed
instructions, please refer to the instructions
provided with the individual accessory.
After unpacking the compressor for the first
time it will be necessary to remove the plastic
transit bung and replace it with the supplied
dipstick.
NOTE: It is advisable to store this bung,
should the compressor require transporting
in the future.
Make sure that the level of oil ranges
between the max. and the min. mark (Fig.1).
After the first 50 working hours, replace the
oil with one of those listed (see page 10).
When the installation procedure is complete,
the compressor is ready for use. Make sure
the pressure switch is positioned 'OFF'. Switch
on the power then position the pressure
switch to the 'ON' position to start the
compressor (Fig.2).
When starting the compressor for the first
time, leave it running for about 10 minutes
with the drain cock (A) open (Fig.3).
DA25/190 does not have a tap. Instead, run
for 10 minutes with a coupling inserted into
the connector.
After this time, ensure the drain cock (A) is
closed correctly. Make sure that pressure in
the tank is correct and that the compressor
stops automatically when the max. pressure is
reached. The pressure is monitored on gauge
(B) (Fig.4).
This operation is automatically controlled by
the pressure switch which stops the motor
when the max. pressure allowed is achieved,
and starts it again when the pressure goes
below the minimum threshold (about 2 bar
less than the max. pressure).
Never unplug the compressor or switch off
the main switch to stop the compressor.
Always position the pressure switch to the
off position.
OPERATION AND USE
Fig.1.
- 6 -
Fig.2.
Fig.3.
(A)
Fig.4.
(B)