Draper 02519 매뉴얼 - 페이지 13

{카테고리_이름} Draper 02519에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 02519 20 페이지. 230v router
Draper 02519에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지)

페이지 인쇄

ASSEMBLING THE BENCH GRINDER

8.1

INSTALLATION

Choose a location that is level, flat and with a lot of

natural light.

The bench grinder should be operated on a work

bench that is high enough to prevent any injury

caused by working in an uncomfortable position;

but not too high that the work piece cannot be

safely viewed from above.

Warning!

Bending over or having your neck bent for too long

(from looking down) can lead to fatigue injuries.

The environment will have a negative result on its

operation if you are not careful. If the air is damp,

components will rust. If the machine is unprotected

from dust and debris; components will become

clogged: And if not cleaned and maintained

correctly or regularly the machine will not perform

at its best.

The work bench should offer enough space around

the bench grinder for all possible applications and

to house any accessories.

Although the bench grinder has been assembled in

the factory, some final assembly and adjustments

will be required before it can be used. The fine

setup will come from experimenting with your new

bench grinder and making small adjustments.

8.2

BENCH MOUNTING YOUR GRINDER – FIG. 1

Securely bolt the bench grinder to a work bench or other secure surface through the various

points in the base (fixings are not supplied).

Ensure there is enough clear space around the grinder to accommodate large items which may

be ground, i.e., garden tools, etc. To reduce any vibration, mount the grinder on a vibration

absorption mat.

8.3

FITTING THE TOOL RESTS – FIG. 2

− Attach the left and right hand tool rests using the fittings from Group (A) shown in

7.2 WHAT'S IN THE BOX section on page 12.

− Fit both tool rests (5) to the inner edge of the wheel guards using the bolts (A1) and washers

(A2) provided.

− Adjust them so there is approx. 1.5mm between the grinding wheel face and the tool rest.

Caution!

Ensure both washers are fitted between the bolt and the tool rest. Neglecting to install the

washers correctly may result in the tip of the bolt contacting the side of the abrasive wheel.

FIG.

(5)

(A1)

(A2)

FIG.

– 13 –