Draper 02520 매뉴얼 - 페이지 8

{카테고리_이름} Draper 02520에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 02520 20 페이지. 230v router
Draper 02520에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지)

페이지 인쇄

HEALTH AND SAFETY INFORMATION

− Ensure that blotters are used when they are provided with the bonded abrasive product and

when they are required.

− Ensure that the abrasive product is correctly mounted and tightened before use and run the

tool at no-load speed for 30 seconds in a safe position – stop immediately if there is

considerable vibration or if other defects are detected. If this condition occurs, check the

machine to determine the cause.

− Never use the tool without such a guard.

− Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels.

− For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is

long enough to accept the spindle length.

− Check that the work piece is properly supported.

− Do not use cutting wheel for side grinding.

− Ensure that sparks resulting from use do not create a hazard – e.g. do not hit persons or ignite

flammable substances.

− Ensure that ventilation openings are kept clear when working in dusty conditions. If it should

become necessary to clear dust, first disconnect the tool from the mains supply (use non

metallic objects) and avoid damaging internal parts.

− Always use eye and ear protection.

− Personal protective equipment such as dust mask, gloves, helmet and apron should be worn.

− The wheel continues to rotate after the tool is switched off.

− Stay alert. Watch what you are doing. Use common sense. Do not operate tool when you are

tired.

Wear proper clothing. Do not wear loose clothing, neckties or jewellery (ring, wristwatches etc.)

to catch in moving parts. Non-slip footwear is recommended. Wear protective covering to contain

long hair. Roll long sleeves above the elbow.

Use safety goggles (Head protection). Wear goggles approved to the relevant standards at all

times. Normal spectacles only have impact resistant lenses, they are NOT safety glasses.

Also, use face or dust mask if application is dusty and ear protectors during all operations.

Sound levels. Some types of machines may have high sound levels when working. In such cases

ear protection must be worn.

Vibration levels. Hand held power tools produce different vibration levels. You should always

refer to the specifications and the relevant Health and Safety guidelines.

Dust extraction. If your tool is fitted with a dust extraction facility, always ensure that it is

connected and being used with a dust extractor. Vacuum cleaners can be used if suitable for the

material being extracted.

Check damaged parts. Before further use of the tool, a guard or other part that is damaged

should be carefully checked to determine that it will operate properly and perform its intended

function;

•

Check for alignment of moving parts, free running of moving parts, breakage of parts,

mounting and any other conditions that may affect its operation. A guard or other part that is

damaged should be properly repaired or replaced by an authorised service centre unless

otherwise indicated in this instruction manual.

Have defective switches replaced by an authorised service centre. Do not use the tool if

•

the switch does not turn it on and off.

Have your tool repaired by a qualified person. This electric tool is in accordance with the

relevant safety requirements. Repairs should only be carried out by qualified persons using

original spare parts, otherwise this may result in considerable danger to the user.

– 8 –