Draper 29621 사용 설명서 - 페이지 5

{카테고리_이름} Draper 29621에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 29621 16 페이지. Bench grinders
Draper 29621에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄

FOR YOUR OWN SAFETY:

Reading and understand the instruction manual before operation.

1. Always wear eye protection which complies to a recognised standard.

2. Wear a mask or respirator when dust is generated.

3. Tighten grinding wheel lock nuts, securing bolts and all clamps and guards.

4. Keep guards in place and working properly.

5. Keep hand clear of grinding wheels.

6. Never reach behind or beneath the grinding wheels.

7. Unplug from power supply before adjusting or servicing.

8. To avoid electric shock do not use in damp conditions or expose to rain.

9. When fitting a new grinding wheel, always check that the stated max. grinding wheel for damage

such as flaws or cracks, then if the wheel appears satisfactory fit the new wheel to the grinder.

10.When a new grinding wheel has been fitted stand to one side of the grinder and switch 'ON'. Let

the grinder operate at full speed for approximately one minute so that any undetected flaws or

cracks will become apparent.

11.Do not attempt to cut anything with the grinding wheel.

CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (230V ONLY)

To eliminate the possibility of an electric shock, your machine has been fitted with a BS approved,

non-rewirable moulded plug and cable which incorporates a fuse, the value of which is 3 amps.

Should the fuse need to be replaced, an

rating, marked thus

If a replacement fuse cover is required, ensure it is of the same colour as that visible on the pin

face of the plug (i.e. red). Fuse covers are available from your Draper Tools stockist.

If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable should

now be suitably prepared and the correct type of plug fitted. See below.

WARNING:

A plug with bare flexible wires exposed is hazardous if engaged in a live power socket outlet.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Green and Yellow - Earth, Blue - Neutral, Brown - Live.

As these colours may not correspond with the coloured markings identifying the terminals in your

plug, proceed as follows:

The wire which is coloured green and yellow must be connected to the terminal in the plug which

is marked with the letter 'E' or by the earth symbol

The wire which is coloured blue must be

connected to the terminal which is marked with the letter 'N' or coloured black or blue.

The wire which is coloured brown must be connected to the terminal which is marked with the

letter 'L' or coloured red or brown.

EXTENSION LEAD CHART:

Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of tool.

Ampere rating

(on name plate)

Extension cable length

7.5

15m

22.5m

30m

45m

ADDITIONAL SAFETY RULES

FOR BENCH GRINDERS

POWER SUPPLY

. The fuse cover is detachable, never use the plug with the cover omitted.

0.75

approved BS1362 fuse must be used of the same

or coloured green or green and yellow.

Wire size mm

0.75

1.25

- 4 -

1.0

1.25

1.5

1.25

1.5

2.5