Draper Storm Force 56457 사용자 설명서 - 페이지 15

{카테고리_이름} Draper Storm Force 56457에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Storm Force 56457 20 페이지. 230v 650w

PREPARING THE ANGLE GRINDER

– Press and hold the spindle lock button (3).

– Loosen the locking flange (4) anti-clockwise using

the pin spanner (7) supplied.

– The spindle may rotate slightly before the spindle

lock fully engages.

– Remove the locking flange only.

– Clean the flanges and spindle prior to fitting any

accessory.

● If the rear flange (4.1) is removed for cleaning,

ensure it locates correctly on the spindle flats

when refitting and does not spin freely.

– When fitting the appropriate accessory please

refer to (FIG.3, on page 14) for specific details on

the locking flange correct orientation as

applicable.

– Securely tighten the locking flange clockwise

using the pin spanner while holding down the

spindle lock (3).

Note: When using wire cup brushes the locking flange

is not required due to the design of the brushes.

When fitted check the accessory is correct and,

importantly fully secure on the spindle.

Warning! Never press the spindle lock button (3)

while the spindle is in motion.

(3)

(7)

FIG.4

(4)

FIG.5

- 15 -

(4.1)