Draper Stormforce 65130 매뉴얼 - 페이지 7
{카테고리_이름} Draper Stormforce 65130에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Stormforce 65130 20 페이지. Air die grinder
페이지 인쇄
5.
HEALTH AND SAFETY INFORMATION
Wait for the machine to stop. Unless the machine is fitted with a safety brake, some parts
may continue to move due to momentum. Wait for all parts to stop, then unplug it from the power
supply before making any adjustments, carrying out maintenance operations or just finishing using
the tool.
Remove and check setting tools. Some machinery requires the use of additional tools or keys to
set, load or adjust the power tool. Always ensure these have been removed and are safely away
from the machine before starting the tool.
Prevent unintentional starting. Before plugging any machine to the power supply, make sure the
switch is in the OFF position. If the machine is portable, do not hold it near the switch and take
care when putting it down, ensuring nothing can operate the switch.
Carefully select an extension lead. Some machines are not suitable for use with extension
leads. If the tool is designed for use outdoors, use an extension lead also suitable for that
environment. When using an extended lead, select one capable of handling the current (amps)
drawn by the machine in use. Fully extend the lead regardless of the distance between the power
supply and the tool. Excess current (amps) and a coiled extension lead will both cause the cable to
heat up and can result in fire.
Concentrate and stay alert. Distractions are likely to cause an accident. Never operate a power
tool if you are under the influence of drugs (prescription or otherwise) or alcohol, or if you are
feeling tired. Being disorientated will result in an accident.
Have this tool repaired by a qualified person. This tool is designed to conform to the relevant
international and local standards and, as such, should be maintained and repaired by someone
qualified, using only original parts supplied by the manufacturer. This will ensure the tool remains
safe to use.
5.2
ADDITIONAL SAFETY INSTRUCTIONS FOR AIR DIE GRINDER TOOLS
WARNING:
− Only insert tools of the correct shaft diameter shall be used.
− Cutting off wheels and routing cutter wheels shall not be used.
− The allowed speed of the insert tool must be higher than the speed of the die grinder.
− The allowed speed of the mounted point must be lowered due to the increase of the length of
the shaft between the end of the collet and the mounting point (overhang). Make sure that the
minimum gripping length of 10mm is observed.
− Working in certain materials creates emission of dust and fumes, causing a potentially
explosive environment.
− Beware of mismatching the insert tool shaft to the collet size. The shaft should be a snug fit
before tightening the collet and should never require pressure to insert. Excessively loose
shafts may result in the bit being thrown during use.
− Beware of excessive vibration levels due to improper mounting or damaged insert tool. Stop
immediately and rectify the cause.
− Attention shall be paid to ensure the maximum permissible pressure is not exceeded. The use
of an inline water separator, lubricator and pressure regulator should be used to control the
pressure of the air being supplied to the power tool.
− The insert tool and output shaft will run on after the trigger has been released.
− Wear close fitting apparel, remove jewellery and tie long hair back to prevent the risk of being
drawn in.
− Ensure any sparks generated pose no threat of ignition to stored gas or fluid.
− In the event of an air line failing the whipping compressed air hose poses a risk of injury or
damage to property. Isolate the air hose from the supply quickly and safely.
– 7 –