Dual Roller 12V Battery FlexShade
Section 5 - Limit Switch Adjustments
Caution:
- Be sure all switches are in "off" position before adjusting limit switches. Be prepared to shut off manually while testing.
- Shade may be damaged by running shade fabric down too far to expose roller.
- If using a group control system, each limit switch must be set prior to connecting to system.
- Motor must be installed so limit switches are pointed down.
Limit Switch Adjustments
1. Switch on the power supply.
The LED switches ON.
2. Press Up and Down buttons on
RTS control point OR Motor head
at the same time: The shade
moves up and down
(fast raising
, and commissioning
and lowering)
process begins.
The RTS control point is pre-
programmed in the motor.
Checking the direction of rotation
1. Press Up button on the RTS control point / Motor head:
a)
If the shade rises
Move onto the section entitled "Setting the end limits".
(B)
b)
If shade lowers
Move onto the next step.
2. Press my / stop button on RTS control point / Motor head until shade
moves up and down: The direction of rotation has been modified.
3. Press Up button on RTS control point / Motor head to check the
direction of rotation.
1.
2.
2.
2.
2.
2.
1.
A
A
my
my
my
my
my
B
B
Validation of the setting
2.
To confirm end limits, press my / stop button until shade moves
up and down.
The end limits are programmed and the LED switches OFF.
Recording the RTS control point
my
The motor is in programming mode:
Quickly press the PROG button on the RTS control point to be
programmed:
The shade moves up and down: this RTS control point is now
programmed.
UP
my
STOP
DOWN
(A)
, the direction of rotation is correct:
, the direction of rotation is incorrect:
2.
3.
3.
3.
3.
my
my
my
my
3.
®
Setting the end limits
The end limits can be set in any order.
1. Raise shade to desired position by pressing Up button.
2. Press my / stop and Down buttons at the same time until shade
moves. The upper end limit is memorized.
3. Press my / stop button when the shade reaches the desired
lowered position. If necessary, adjust the position of shade using
the Up and Down buttons.
4. Press my / stop and Up buttons at the same time until shade
moves. The lower end limit is memorized. The shade rises and
stops in raised position.
1.
1.
my
3.
3.
3.
my
my
my
my
my
my
STOP
2.
1.
2.
my
4.
4.
4.
my
STOP
STOP
4.
Pen
my
Programming
Button
page 6 of 7
2.
my
my
3.
페이지 인쇄