Draper LightBloc ZIP 92 설치 및 작동 지침 - 페이지 4
{카테고리_이름} Draper LightBloc ZIP 92에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper LightBloc ZIP 92 12 페이지.
페이지 인쇄LightBloc ZIP™ 92 & ZIP 127
Section 3 - Attaching Mounting Brackets to Headbox for Direct Mounting to Ceiling or Wall
1.
Attach Mounting Brackets to the
Headbox as a spacer between
the Headbox and the wall.
Please Note: Leave
a 1 ¾"
(44mm)
between Endcap and
Mounting Bracket.
B
C
Figure 4-B
Section 4 - Direct Mounting to Ceiling or Wall
Please Note: If no cable exit
is provided, drill one now.
1.
Using the mounting
holes in the
endcaps as a guide,
drill pilot holes on
both ends of the
Headbox.
L L
W A
gap
E
A
4.
Figure 5
Figure 4-A
3.
Remove Roller Assembly.
A.
Remove screws from bottom of Headbox.
B.
Remove Fascia and set aside.
C.
Remove Quick Release Pin from Idler End
of Roller Assembly.
D.
Remove Motor
Clip
(Operator End
of Roller Assembly)
E.
Remove Roller Assembly,
Idler End first, and
carefully set aside.
Proceed to
Section 4.
(Optional)
2.
Tighten set
screws.
.
Figure 4-C
CEILING
MOUNT HOLES
2.
Attach to mounting surface
using appropriate fasteners.
Please Note: Installer is
responsible for selecting
mounting hardware
appropriate for site
conditions.
WALL
MOUNT HOLES
page 4 of 12
(Optional)
D