Draper SKYLIGHT 2 FLEXSHADE 사용 설명서 - 페이지 3

{카테고리_이름} Draper SKYLIGHT 2 FLEXSHADE에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper SKYLIGHT 2 FLEXSHADE 8 페이지. Motor operated skylight shades for very large applications

페이지 인쇄

SKYLIGHT 2 FLEXSHADE

Section 1 - Endcaps

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

1. Mark wall, jamb, or ceiling for placement of mounting brackets.

2. Drill small starter holes

(if necessary)

3. Mount brackets using appropriate fasteners for surface

4. Mount fabric/roller assembly. Make sure limit switches are accessible from below the unit

5. Install optional bracket covers

Skylight 2 FlexShade -

Fabric/Roller Installation

Section 2 - Connect Unit to Power

Shade operates on 110-120V, 60 Hz current. Shade is shipped with internal wiring complete and control switch

cable lead. Wire to connect shade to switch

cm)

attached wiring diagram, and wiring should comply with national and local electrical codes. DO NOT wire motors in parallel without written permission from Draper. All

operating switches should be "off" before power is connected.

Please Note: For low-voltage wiring requirements, Draper recommends consulting with a professional low voltage electrical contractor. It is very important that

shielded and stranded CAT 5 cable be used to prevent any electrical interference. See wiring diagrams on page 7.

Section 3 - Hem Bar

Please Note: Please refer to Figure 2 below.

1. Remove one endcap from hem bar.

2. Remove fabric retainer.

3. Slide fabric retainer into hem pocket.

4. Slide hem bar onto fabric panel and retainer.

5. Replace endcap.

6. Center fabric panel in hem bar assembly.

in mounting surface.

(Figure 1 for bracket dimensions)

(if provided)

Figure 1

and switch

to power supply should be furnished by installer. Connections should be made in accordance with

(es)

(Figure 1)

Figure 2

Skylight 2 FlexShade - Hem Bar Installation

fully boxed, and standardly supplied with a 6'

(es)

page 3 of 8

(183