Draper 16061 사용 설명서 - 페이지 11

{카테고리_이름} Draper 16061에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 16061 20 페이지. 400w 230v oscillating multi-tool kit
Draper 16061에 대해서도 마찬가지입니다: 대상 지침 (16 페이지)

페이지 인쇄

BASIC MULTI-TOOL OPERATIONS

8.1 ATTACHING THE SANDING PADS -

FIGS. 1 - 2

CAUTION: For all work or when changing application

tools, always wear protective gloves. Avoid danger of

injury from the sharp edges of the application tools.

Application tools can become very hot while working,

presenting danger of burns.

WARNING: To reduce the risk of injury, do not let the

universal saw blades or any segment saw blades face

back toward the user's hand.

Unscrew the bolt

tool holder, the application tool and the bolt

flange

Place the application tool exactly onto the hex-shaped

tool holder. Note that the application tool has a flush

fit. Reposition the flange and tighten the bolt

(Fig.2) using the supplied hex. key.

NB: Ensure bolt

Failure to do this will result in poor performance.

8.2 MOUNTING/CHANGING THE SANDING

SHEET - FIG. 3

Align the sanding sheet

sanding pad

by hand.

Align the holes of the perforated sanding sheets with

the holes of the perforated sanding pads when used.

Firmly press the power tool with the sanding sheet

against a flat surface and briefly switch the power tool

on. This provides for good adhesion and prevents

premature wear. If one point has become worn, pull off

the sanding sheet, turn it 120° and replace.

8.3 OPERATING THE ON/OFF SWITCH - FIG. 4

Switch the power tool ON.

Slide switch

forward to "I".

Switch the power tool OFF.

Slide switch

forward to "O".

and remove flange

and flange

are tightened firmly.

and press it onto the

FIG.1

. Clean the

and

FIG.2

FIG.3

FIG.4