Draper 300W 대상 지침 - 페이지 10
{카테고리_이름} Draper 300W에 대한 대상 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 300W 16 페이지.
페이지 인쇄
8.
SETTING UP THE SANDER
8.1
SWITCH - FIG. 1
Ensure the sander is raised off the workpiece.
To OPERATE press the trigger
To use CONTINUOUSLY press trigger
button (3) and hold in. Release trigger
Release button (3), the machine will continue to
run.
To STOP the machine press trigger
button
will automatically release.
This machine is intended for light/medium duty
sanding of wood and similar materials only.
Apply equal pressure on the workpiece with the
base pad remaining flat. Attempting to sand
areas using only the edge will lead to damage to
the base pad.
NOTE: Excess pressure when sanding reduces the
effectiveness of tool and will cause the motor to
overload.
Do not overload this machine.
Abrasive sheets are consumable items. Replace
abrasive sheets when clogged with material or
when surface/edge has rips, cracks or worn
areas.
8.2
ABRASIVE SHEET INSTALLATION /
REPLACEMENT - FIG.2
In order to fix the abrasive paper, proceed as follows:
1.
Open one fixing clamp
the abrasive paper into the exact position. Close
clamp.
2.
Position the sheet of abrasive paper on the base
pad and wrap the sheet around the front of the
base pad
.
3.
Open the second clamp
end of the abrasive paper then close clamp.
Check that the sheet is firmly secured and that it
completely covers the base pad of the tool.
Abrasive sheet must be centrally positioned and
taught over the base pad.
10
.
, press
.
once and
and insert one end of
and insert the other
FIG.1
FIG.2