Draper 98427 사용 설명서 - 페이지 7
{카테고리_이름} Draper 98427에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 98427 20 페이지. 230v oscillating spindle sander
페이지 인쇄
5.
HEALTH AND SAFETY INFORMATION
before making any adjustments, carrying out maintenance operations or just finishing using the
tool.
Remove and check setting tools. Some machinery requires the use of additional tools or keys to
set, load or adjust the power tool. Before starting the power tool always check to make certain they
have been removed and are safely away from the machine.
Prevent unintentional starting. Before plugging any machine in to the power supply, make sure
the switch is in the OFF position. If the machine is portable, do not hold the machine near the
switch and take care when putting the machine down, that nothing can operate the switch.
Carefully select an extension lead. Some machines are not suitable for use with extension
leads. If the tool is designed for use outdoors, use an extension lead also suitable for that
environment. When using an extended lead, select one capable of handling the current (amps)
drawn by the machine in use. Fully extend the lead regardless of the distance between the power
supply and the tool. Excess current (amps) and a coiled extension lead will both cause the cable to
heat up and can result in fire.
Concentrate and stay alert. Distractions are likely to cause an accident. Never operate a power
tool if you are under the influence of drugs (prescription or otherwise), including alcohol or if you
are feeling tired. Being disorientated will result in an accident.
Have this tool repaired by a qualified person. This tool is designed to conform to the relevant
international and local standards and as such should be maintained and repaired by someone
qualified, using only original parts supplied by the manufacturer. This will ensure the tool remains
safe to use.
5.2
ADDITIONAL SAFETY INSTRUCTIONS FOR SANDERS
Safety is a combination of operator common sense and alertness at all times when the sander is
being used.
Warning! For your own safety, do not attempt to operate the oscillating spindle sander until it is
completely assembled and installed according to the instructions and until you have read and
understand the following.
There may be a tendency for the machine to tip over or move during certain operations, due to
this, the sander must be bolted down.
The machine should be positioned so the operator or a casual observer are not forced to stand in
line with the sanding sleeve. This machine is intended for indoor use only.
Always wear safety goggles (not glasses) that comply to a recognised standard. Wear a face mask
if the operation is dusty. Wear ear plugs or muffs during extended periods of operation. Do not
wear gloves, jewellery or watches. Roll long sleeves above the elbow. Tie back long hair.
Do not sand pieces of material too small to hold comfortably by hand.
Avoid awkward hand positions, where a sudden slip could cause a hand to move into the sanding
sleeve.
Never stand on the machine.
Never turn your sander "ON" before clearing the belt table and worktable of all objects.
Make sure the sanding sleeves runs in the right direction. Always have it adjusted correctly so
that the sleeve does not run off the spindle.
Always adjust the worktable to within a maximum of 2mm off the sanding sleeve.
When sanding a large piece of material, provide additional support at table height.
Never leave when the machine is on, wait until the machine has come to a complete stop.
Do not perform assembly or adjustment work on the table while the sander is operating.
Turn sander "OFF" and remove plug from power supply before removing any accessories.
– 7 –