BCS 738 사용 설명서 - 페이지 10
{카테고리_이름} BCS 738에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BCS 738 20 페이지. Two wheel tractors
BCS 738에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Safety
- 3. Controls Description
- 4. Sound & Vibration Levels
- 5. Assembly Instructions
- 6. Attaching Implements
- 7. Operation
- 8. Maintenance Guide
- 9. Maintenance Programme
- 10. Service Information
- 11. Troubleshooting Guide
- 12. Risk Assessment
- 13. Service Record
- 14. Manufacturer's Information
BCS Two Wheel Tractor Power Unit
Use handlebar adjuster (G) to set handlebar height.
Hold the handlebar and pull up the clutch lever (C).
Depress the OPC lever (A) and select the correct working speed using the gear lever (D).
Ensure forward/reverse lever is in the correct position to move forward (L):
If the handlebars are positioned over the engine then this lever should be in the fully back
position.
If the handlebars are positioned over the implement then it should be in the fully forward
position.
Engage drive to the working implement by using the PTO lever (E):
If the handlebars are positioned over the engine then pull the PTO lever (E) towards you.
If the handlebars are positioned over the implement then push the PTO lever (E) away from
you.
Release clutch lever (C) slowly and fully, keeping the red machine stop lever depressed as the
machine will stop if released.
Move the throttle lever to the correct position for the implement you are operating - please refer to
the Implement Manual.
Commence work
Close the throttle (F).
Engage clutch lever (C).
Locate gear lever (D) in neutral position.
Disengage drive to the digging knives by pulling the PTO lever (E) backwards.
Release clutch lever (C).
Release the OPC lever (A) completely.
Move the engine stop lever (B) to position O 'STOP'.
WARNING: THE EXHAUST COVER MAY BE HOT - DO NOT TOUCH.
Page 10
Operation
To Stop Engine
TWT/PU/0617