Drawell SMART Series 사용자 설명서 - 페이지 8

{카테고리_이름} Drawell SMART Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Drawell SMART Series 12 페이지. Biological microscope

SMART Series Biological Microscope

5.1 Installing

Connect the C-mount with CCD camera or connect camera with camera adaptor, then connect it with

c-mount, finally put it into microscope.

5.2 Using

First get a clear image from eyepiece, then put out lever on the side of trinocular head, and collect

image with camera. Clear image should be in screen. Adjust B14 fine focusing knobs to get it clear if

image isn't clear.

6. Maintenance

6.1 Clean microscope

6.1.1 Don't touch the lens with hand, Dust on lens should be cleaned by soft brush or absorbent

cotton or cleaned by absorbent cotton, lens paper with the mixture of alcohol and ether (proportion

1:4).

6.1.2 Alcohol and ether all are burnt early, please take them away from fire. Be careful for turn on

and off power.

6.1.3 Don't clean painted metal and galvanizing metal with organic solvent such as alcohol, ether or

the mixture of the both. Silicon cloth or soft cleaning preparation is suggested to clean it.

6.1.4 Plastic should be cleaned by soft cloth with clear water.

6.2 Environment of using and placing

6.2.1 Microscope should be used and placed in a cool, dry, non-dust, non-shake and non-corrosive

gases environment.

6.2.2 Microscope should be used in environment of indoor temperature 0°-40°C and maximum

relative humidity 85%.

6.2.3 Removing equipment is suggested to be installed when microscope used in heavy humidity

area to avoid fungus and mist damage instrument.

6.2.4 Please pay attention to prevent microscope from violent shake and vibration in application and

in carrying. Don't drag it on the surface of worktable to avoid damage to microscope and worktable.

6.3 Replacement of bulb

6.3.1 Turn off power, and pull out plug.

6.3.2 Wait the bulb become cool.

▲ Please be sure that the bulb is cool, then follow

by the nest operations.

6.3.3 Lay aside the microscope reliably, unscrew the

knurled thumb screw of the lamp housing cover on

the underside of base.

6.3.4 Pull over the lamp housing cover.

6.3.5 Pull out the bulb should be replaced, hold a

-７-