Drawmer DA 6 운영자 매뉴얼 - 페이지 6
{카테고리_이름} Drawmer DA 6에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drawmer DA 6 12 페이지. Stereo distribution pre-amp
Drawmer DA 6에 대해서도 마찬가지입니다: 운영자 매뉴얼 (6 페이지)
페이지 인쇄
For the purposes of monitoring each output, a stereo ¼" (TRS) jack socket is offered on
the front panel. This having the standard wiring convention of Tip being Left; Ring being
Right; and Sleeve being common Ground. This output is capable of driving headphones
with an impedance between 8 and 600. The amplifier has an output of approximately
1Watt. Caution is required when operating at high output levels with low impedance
headphones.
DRAWMER do NOT accept any responsibility for damage caused to
operator hearing or speaker devices by use of excessive output levels.
The DA6 unit will be supplied with a power cable suitable for domestic power outlets in
your country. For your own safety, it is important that you use this cable to connect to
the mains supply earth. The cable must not be tampered with or modified.
The power supply socket has an integral fuse drawer containing the power fuse (and a
spare) both of the same value, to suit the mains voltage for which the unit has been
supplied. Removal of the drawer is only possible with the power cord removed. The fuse
should never blow under normal operation. If the fuse is suspected of having blown,
then a fault will have occurred and this fault condition should be inspected by a qualified
service engineer. When replacing the fuse, always comply with the Safety Instructions.
If the unit is to be used with a mains input operating voltage different to that for which
the unit is supplied, the following procedure must be carried out by a technically
competent person, (see following diagrams)
1:
Disconnect the unit from the mains.
2:
Using a number 1 size pozidrive screwdriver, remove the seven self
-tapping screws that retain the top cover. Two screws are found along
each side; two along the top edge at the rear; and the upper central screw
on the front facia panel.
3:
Slide the voltage change-over switch (SW8) until the correct (or nearest)
mains input voltage is visible on the switch actuator.
MONITOR HEADPHONES
POWER CONNECTION
DA6 OPERATORS' MANUAL