Drawmer DA 6 운영자 매뉴얼 - 페이지 5

{카테고리_이름} Drawmer DA 6에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drawmer DA 6 6 페이지. Stereo distribution pre-amp
Drawmer DA 6에 대해서도 마찬가지입니다: 운영자 매뉴얼 (12 페이지)

페이지 인쇄

The DA6 has been designed for ease of use. It operates on balanced or unbalanced signal

levels in the range -15dB to +15dB.

Input L&R

These controls should be used to set the optimal input gain for

both Left and Right signals. Use the display above to ensure the

correct operating levels are being attained. Adjustment in the

range +/-15dB is possible. Separate controls are offered to permit

the re-alignment of any offset stereo image.

Input Display

Since the DA6 is normally used as a line amplifier, then it is quite

acceptable to see' signals in the positive gain region of this

display. However, ensure that the +15dB LED never illuminates

other than for brief instances, otherwise distortion will occur.

Output L&R

These controls should be used to set the optimal output level to

match the input section of the connected device, for both Left

and Right signals. Adjustment of +/-15dB is possible. Normally,

any stereo image offset will have been corrected by the

Left/Right input controls. However separate output controls are

also offered to give total control of the stereo image.

Mono/Stereo

Selects whether the output is to be separate Stereo signals or

summed' to produce a Mono signal. LED show the status.

Chan Select

This rotary switch selects which stereo (or mono) output is to be

routed through to the stereo headphone amplifier.

H/Phone

This control determines the amount of headphone amplifier drive.

Caution should be used when using high output levels and low

impedance headphones.

Output Display

This display shows the stereo output levels of the selected

channel feed to headphones, removing the need to utilise

headphones as a method of monitoring the output signals.

CONTROL DESCRIPTION