Bosch 300 Series 사용 설명서 - 페이지 32

{카테고리_이름} Bosch 300 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 300 Series 50 페이지. Built-in wall ovens
Bosch 300 Series에 대해서도 마찬가지입니다: 사용 설명서 지침 (40 페이지), 사용자 설명서 (21 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (36 페이지), 설치 매뉴얼 (32 페이지), 사용 및 관리 설명서/설치 지침 (40 페이지), 빠른 시작 및 안전 매뉴얼 (7 페이지), 설치 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (7 페이지), 사용 및 관리 매뉴얼 (32 페이지), 빠른 시작 및 안전 매뉴얼 (7 페이지), 서비스 매뉴얼 (36 페이지), 빠른 시작 및 안전 매뉴얼 (13 페이지)

페이지 인쇄
Bosch 300 Series 사용 설명서
en-us Operating the Dishwasher
Time display
When a wash cycle is selected the
remaining wash cycle time is shown
on the display 8.
The wash cycle time is determined
during the wash cycle by the water
temperature, the amount of dishes,
as well as the degree of soiling and
may vary (depending on the selected
wash cycle).
Delay start
You can delay the start of the cycle in
one hour increments up to 24 hours.
œ:‹‚ 1 hour delay
œ:ƒ... 24 hours delay
To set Delay start:
Press On/Off button (. Select a
1.
cycle.
Press Delay button @ until the
2.
displayed time corresponds with
your requirements.
Press Start button P to activate
3.
Delay start.
To cancel Delay start:
Press Delay button @ until œ:‹‹
1.
is indicated on the digital
display 8.
Press Start button P to save
2.
setting.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
32
Wash cycle end
The wash cycle has ended when the
display 8 reads ‹:‹‹.
If the signal tone has been set, the
wash cylce end is also indicated by a
buzzer.
Off
›:‹‹
low
›:‹‚
medium
›:‹ƒ
loud
›:‹„
To change the signal volume:
Open the door.
1.
Press the On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 indicates š:‹x (x can
be any number). Release both
buttons.
Press function key # until the
4.
display shows ›:‹ƒ.
Press function key 3. Each time
5.
the button is pressed the set
value increases by one level;
when it reaches the value ›:‹„,
the display jumps back to ›:‹‹
(off).
Press Start button P to save
6.
the setting.