Bosch 800 Series 사용 및 관리 매뉴얼 - 페이지 6

{카테고리_이름} Bosch 800 Series에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 800 Series 12 페이지. Built-in wall ovens
Bosch 800 Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (24 페이지), 설치 매뉴얼 (40 페이지), 설치 매뉴얼 (23 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (32 페이지), 사용 설명서 (32 페이지), 설치 매뉴얼 (32 페이지), 빠른 시작 및 안전 매뉴얼 (7 페이지), 사용 및 관리 매뉴얼 (40 페이지), 설치 매뉴얼 (40 페이지), 설치 매뉴얼 (32 페이지), 설치 지침 매뉴얼 (40 페이지), 설치 매뉴얼 (48 페이지), 사용 및 관리 매뉴얼 (33 페이지), 사용 및 관리 매뉴얼 (49 페이지), 빠른 시작 매뉴얼 (7 페이지), 빠른 시작 및 안전 매뉴얼 (13 페이지), 설치 매뉴얼 (32 페이지), 서비스 매뉴얼 (36 페이지), 설치 지침 매뉴얼 (29 페이지), 사용 및 관리 매뉴얼 (24 페이지), 사용 및 관리 매뉴얼 (40 페이지), 설치 지침 매뉴얼 (28 페이지)

페이지 인쇄

Causes for damages

CAUTION

Risk of damage due to corrosion. Always turn

appliance on when cooking to avoid condensation

buildup. Condensation can lead to corrosion

damages.

Always replace burnt out bulbs immediately to avoid an

overload of the remaining bulbs.

Protecting the environment

Unpack the appliance and dispose of the packaging in

line with environmental requirements.

Operating modes

You can use this appliance in the air extraction or the

recirculation mode.

Exhaust air mode

The air that is drawn in is cleaned by

the grease filters and conveyed to the

exterior by a pipe system.

Note: Ventilation may not exit through an already

operational smoke or exhaust chimney, nor a duct used

for ventilating furnace installation areas.

If the ventilation is intended to pass through a smoke

or exhaust chimney that is not in operation, the

responsible area heating inspector must give approval.

If the ventilation passes through an external wall, use a

telescoping wall sleeve.

Risk of damage due to the presence of humidity in the

electronic circuitry. Never clean operator controls with a

wet cloth.

Surface damage due to incorrect cleaning. Clean

stainless steel surfaces in the grain direction only. Do not

use any stainless steel cleaners for operator controls.

Surface damage due to strong or abrasive cleaning

agents. Never use strong and abrasive cleaning agents.

Risk of damage from condensation back flow. Install

exhaust vent at a slight downward slope away from the

appliance (1° slope).

Re-Circulating air mode

The air that is drawn in is cleaned by the

grease filters and an activated carbon filter

and conveyed back into the kitchen.

Note: To capture odors in re-circulating air mode, you

must install the recirculating air kit with an activated

carbon filter. The different options for operating the

appliance in re-circulating air mode can be found in the

User Manual.

Alternatively, ask your dealer. The required accessories

are available for purchase from specialist retailers,

from customer service or from the Online Shop.

The accessory numbers can be found at the end of the

instructions for use.