Bosch Benchmark HBLP451RUC 설치 매뉴얼 - 페이지 10

{카테고리_이름} Bosch Benchmark HBLP451RUC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Benchmark HBLP451RUC 39 페이지. Built-in wall ovens
Bosch Benchmark HBLP451RUC에 대해서도 마찬가지입니다: 사양 (3 페이지), 설치 매뉴얼 (22 페이지), 서비스 매뉴얼 (45 페이지)

페이지 인쇄

Installing the Oven

WARNING

•

Make sure oven is cool and power to the oven

has been turned off before removing the door.

Failure to do so could result in burns.

•

The oven door is heavy and fragile. Use both

hands to remove the oven door. The door front

is glass. Handle carefully to avoid breaking.

•

Grasp only the sides of the oven door. Do not

grasp the handle as it may swing in your hand

and cause damage or injury.

•

Failure to grasp the oven door firmly and

properly could result in personal injury or

product damage.

•

To avoid injury from hinge bracket snapping

closed, be sure that both levers are securely in

place before removing the door. Also, do not

force door open or closed - the hinge could be

damaged and injury could result.

•

Do not lay removed door on sharp or pointed

objects as this could break the glass. Lay on a

flat, smooth surface, positioned so that the

door cannot fall over.

Bottom Hinge Doors Only - Remove

Prior to Install

Important: Do not attempt to remove the side hinge

door (side hinge doors are found only on select models).

Ovens with bottom hinge doors permit the oven door(s) to

be removed prior to lifting the unit into place. Each door

weighs approximately 40 pounds (18.1 kg). Removing and

replacing the door are routinely simple procedures.

Removing the door lightens the unit significantly and

provides easier access to the recommended

handhold

inside the oven cavity. See instructions below.

Be sure to read all

warnings and cautions

in the installation

manual regarding the

door removal before

attempting to remove

the door.

Open the door

completely.

Flip latch levers on

hinges toward you.

Holding the door firmly

on both sides and

using both hands,

close the door gently

until it stops against

the latch levers, about

30 ° from the closed

position.

Carefully lift the door

up and out of the

hinge slots. Hold

firmly; the door is

heavy.

Place the door in a

convenient and stable

location until you are

ready to reinstall it.

Lay the door on a

towel or section of

protective foam

padding to avoid

damage to the door or

the floor.

Placing the Oven Unit Into the Cabinet

Opening

CAUTION

To avoid damage to the door do not lift, pull or push

the unit during installation by using the oven door

handle as a gripping point.

It is recommended to wear gloves and long sleeves

to protect hands and forearms from abrasion and

potential scratches during the lifting process. It is

also recommended

to take off watches and jewelry

and to wear work shoes during installation for foot

protection.

When lifting the unit into place avoid grasping the upper

element to avoid damaging it. See the illustration following

for the correct lifting point for a bottom hinge double oven

with the lower door removed. This illustration shows a

detailed view of the oven cavity. Note the location of the

ridge inside the top of the cavity. This is the area to grip

from the front when lifting the oven.

For your particular oven type, see the preceeding section

"Lifting Recommendations

Vary Dependent Upon Oven

Door Type" for lift points.

English 8

9001065629 Rev A