Bosch Benchmark HBLP451RUC 설치 매뉴얼 - 페이지 5

{카테고리_이름} Bosch Benchmark HBLP451RUC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Benchmark HBLP451RUC 39 페이지. Built-in wall ovens
Bosch Benchmark HBLP451RUC에 대해서도 마찬가지입니다: 사양 (3 페이지), 설치 매뉴얼 (22 페이지), 서비스 매뉴얼 (45 페이지)

페이지 인쇄

Preparation

Before You Begin

Tools and Parts Needed

•

Phillips head screwdriver

•

Star-head screwdriver (T20)

•

Measuring tape

•

Drill with bit (1/8")

•

Gloves

Parts Included

•

Phillips head screws (6)

General

Information

Power Requirements

The outlet must be properly grounded in accordance with

all applicable codes.

For Best Installation

The oven can be difficult to handle during installation. It is

recommended to have three or more people available to

assist with lifting the unit into place.

Removal of the bottom hinge oven door during installation

(to provide the necessary handholds and to significantly

reduce the unit weight) can be cumbersome unless the

detailed door removal instructions are followed carefully.

Note: Do not attempt to remove the side hinge door (some

models).

Please take time to read and follow the instructions

provided for an improved installation experience.

Use this checklist to verify that you have completed each

step of the installation process. This can help you avoid

mistakes.

1. Before installing the oven, be sure to verify the

cabinet dimensions are correct for your unit and

the required electrical connections are present.

Refer to the installation manual for content

regarding Safety, Cabinet Dimensions, Removing

Packaging, Electrical Installation, Testing the

Installation and Customer Service.

Remove bottom hinged oven door(s) (not side

swing doors) to reduce the unit weight and to

provide access to handholds for lifting.

Move the oven unit into place in front of the cabinet

opening, leaving the bottom packaging on the unit

to avoid damaging flooring.

Remove the torx head (T-20 size) screws holding

the unit to the base of the carton (using Star-head

screwdriver).

Team lift the unit directly into the cabinet cutout

taking care not to pinch fingers or scratch hands or

arms. Make sure the electrical conduit reaches to

the connection point properly.

Slide the unit all the way into place, making sure to

route the electrical conduit correctly.

Fasten the oven unit to the cabinetry opening with

the screws supplied (using Philips screwdriver).

Reinstall the oven door(s) removed in step 3

above.

10. Consult the complete installation instructions and

follow the remainder of the procedures listed,

including performing an operation test.

11. All product literature and accessories (may be

wrapped or boxed) with the oven.

12. INSTALLER - Leave the literature pack and the

accessories with the customer.

9001065629 Rev A

English 3