Bosch Benchmark HBLP651LUC 서비스 매뉴얼 - 페이지 18
{카테고리_이름} Bosch Benchmark HBLP651LUC에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Benchmark HBLP651LUC 45 페이지. Built-in wall ovens
Bosch Benchmark HBLP651LUC에 대해서도 마찬가지입니다: 사양 (3 페이지), 설치 매뉴얼 (39 페이지), 설치 매뉴얼 (22 페이지)
페이지 인쇄
58300000181895 ARA EN A
4. Lift the liner away from the rest of the door assembly and set
aside.
5. Remove the screws at the top left and top right which secure
the handle to the door assembly.
6. Carefully lift the inner support frame with glass pack and
hinges away from the outer door glass/skin assembly and lay
flat on the work surface.
Figure 14 Removing inner support frame assembly
7. Lift the two pieces of insulation off the inner support frame
assembly and set aside.
8. Remove the screws on the upper right and lower left which
secure the hinges to the inner support frame.
Figure 15 Location of screws securing hinges to inner support frame assembly
9. Lift the inner support frame upwards to access the hinges.
10. Install new right and left hinges and reassemble the door.
11. Test operation of the door by fully opening and closing it
several times.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
6.1.3
CAUTION
Wear protective gloves when disassembling the door. When replacing the
glass pack due to broken glass, exercise extra care to avoid injury from
broken glass.
To access the glass pack...
1. Remove the door as described in the Removing and Reinstalling
the Door section.
2. With the porcelain-coated door liner up, remove the two screws on
each side of the door liner.
3. Remove the screws along the bottom of the door assembly.
Figure 16 Removing door liner screws
4. Lift the liner away from the rest of the door assembly and set
aside.
5. Remove the screws at the top left and top right which secure the
handle to the door assembly.
6. Carefully lift the inner support frame with glass pack and hinges
away from the outer door glass/skin assembly and lay flat on the
work surface.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Replacing the 2-Pane Glass Pack
Page 18 of 45
800 944-2904