Bosch Benchmark HBLP651LUC 서비스 매뉴얼 - 페이지 21

{카테고리_이름} Bosch Benchmark HBLP651LUC에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Benchmark HBLP651LUC 45 페이지. Built-in wall ovens
Bosch Benchmark HBLP651LUC에 대해서도 마찬가지입니다: 사양 (3 페이지), 설치 매뉴얼 (39 페이지), 설치 매뉴얼 (22 페이지)

페이지 인쇄

58300000181895 ARA EN A

7. Confirm that the adjustment cam on the lower hinge is correctly

positioned within the slot in the front frame and rear support

bracket located directly behind the front frame. If the hinge is fully

flat against the front frame and is resting against the side trim, the

cam should be in the correct position.

8. Re-install the three torx screws in the lower hinge.

6.2.2

Aligning the Door

Smooth operation of the door requires proper alignment of the striker

and the catch receiver. When aligned correctly, the door will smoothly

pull itself closed when the striker engages the receiver.

Figure 23 Correctly aligned left-hinge door

If the door is too high, there will be interference between the striker

and a part within the catch receiver, causing the catch receiver and

striker to contact each other in a hard crash.

If the door is slightly too high, when the closed door is pushed

downward, the door will bounce against the striker.

Figure 24 Door out of alignment - too high

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

Door too high

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

JUNE 2014

Service Manual for Bosch Benchmark Series Built-in Wall Ovens

If the door is too low, a bump will be felt when the striker comes into

contact with the re-alignment roller within the catch receiver.

Figure 25 Door out of alignment – too low

Alignment Procedure



NOTICE



All adjustments to the door alignment are made to the lower

hinge only. The upper hinge is fixed and cannot be adjusted.



Each left or right ¼ turn of the alignment cam screw will

result in ~ ½ inch (1.5mm) movement at the door catch.

1. Open door to 135°.

2. Using a T-20 torx driver, loosen the three screws on the lower

hinge by one to two full turns.

3. Using a #2 Phillips-head screwdriver, turn the screw which

controls the alignment cam right or left ¼ turn (1mm).

Left-hinge Door

 If the door is too low, turn the alignment screw to the right.

 If the door is too high, turn the alignment screw to the left.

Right-hinge Door

 If the door is too low, turn the alignment screw to the left.

 If the door is too high, turn the alignment screw to the right.

Door too low

Page 21 of 45

800 944-2904