Bosch Benchmark Series 설치 지침 매뉴얼 - 페이지 11
{카테고리_이름} Bosch Benchmark Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Benchmark Series 40 페이지. Built-in wall ovens
Bosch Benchmark Series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (36 페이지), 설치 매뉴얼 (32 페이지), 빠른 참조 매뉴얼 (4 페이지), 서비스 매뉴얼 (45 페이지), 빠른 시작 및 안전 매뉴얼 (13 페이지)
페이지 인쇄
Mounting the back-pressure flap
Using 4 screws (4x8 mm), attach the back-pressure flap
to the extractor hood.
Connecting the air extractor (only for
ducted operation)
Note: If an aluminum pipe is used, smooth the
connection area beforehand.
Attach exhaust air pipe and seal.
1.
Check whether the back-pressure flap works.
2.
Mounting the recirculation model (only for
circulating-air mode)
Use 4 screws (4x8 mm) to screw the housing for the
1.
recirculation module to the angle bracket.
A
Screws
B
Recirculation module
C
Angle bracket
Measure the distance (x) between the lower edge of
2.
the housing for the recirculation module and the lower
edge of the back-pressure flap.
A
Recirculation module
B
Clamps
C
Flue duct
D
Exhaust air duct
Shorten the exhaust air pipe to the length measured.
3.
Remove the recirculation module.
4.
Push the exhaust air pipe onto the bottom of the
5.
recirculation module.
Position the recirculation module with exhaust air pipe
6.
over the air extraction duct of the extractor hood.
Use 4 screws to fasten the recirculation module to the
7.
angle bracket.
Secure connections with clamps.
8.
11