ADVANCED EV EV1 매뉴얼 - 페이지 13

{카테고리_이름} ADVANCED EV EV1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADVANCED EV EV1 18 페이지.

Maintenance

Before charging:

Only add distilled water. If fluid is below

the top of the plates, add just enough to

cover plates.

After charging:

Check that the fluid level is appropriately

1/4 to 1/2 inch above the plates and 1/4 to

3/8 inch below the level is low. Add

distilled water carefully. Adding distilled

water after charging helps prevent boiling

over.

A Battery cap

B Plates

C Maximum fluid level

D Minimum fluid level

Normal tap water contains minerals

which are harmful to a battery;

therefore, refill only with distilled water.

3. Using a hydrometer, check the specific

gravity of the battery fluid in each cell

against the readings on the chart below.

Consult an AdvancedEV dealer if any low

readings are found.

Temperature

S a t i s f a c t o r y

Hydrometer Reading

Maintenance

2 . link the cables as the picture

When installing the batteries:

1. Please carefully place the cables and make them down, making sure

the cables not crossover the vent caps.

2. Always remove the negative(-) cable from the motor controller first,

and install it at last.

3. Do not over-tighten the battery nuts, because too much force would

damage the battery case.