Bosch CMG7241 2 Series 사용자 설명서 및 설치 지침 - 페이지 15
{카테고리_이름} Bosch CMG7241 2 Series에 대한 사용자 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch CMG7241 2 Series 48 페이지.
페이지 인쇄Note: If you open the appliance door during operation,
the appliance stops heating. When you close the appli-
ance door, the appliance continues to heat again. To
operate your appliance so that it is Sabbath-compliant,
do not open the appliance door until after operation.
1.
Change the "Lighting" basic setting to "Always off".
→ "Basic settings", Page 21
This will ensure that the light in the cooking com-
partment is always off while the appliance is in oper-
ation and when you open the appliance door.
2.
Set the required operating mode.
→ "Setting the operating mode", Page 14
→ "Setting the type of heating and the temperature",
Page 14
3.
Set the required cooking time depending on the op-
erating mode.
→ "Setting the cooking time", Page 15
→ "Time-setting options", Page 15
9 Time-setting options
Time-setting options
Time-setting options
For an operation, you can set the cooking time and the
time at which the operation should be finished. The
timer runs independently of the operation.
Time-setting
Use
option
Cooking time
If you set a cooking time, the appli-
ance stops heating automatically
once this time has elapsed.
End time
Along with the cooking time, you can
set the time at which you want the
operation to end. The appliance
starts up automatically so that the
operation finishes at the required
time.
Timer
You can set the timer to run inde-
pendently of the appliance during op-
eration. It does not affect the appli-
ance.
9.1 Setting the cooking time
You can set the cooking time for the operation up to
24 hours.
Requirement: An operating mode and temperature or
level have been set.
1.
Press
"Cooking time".
2.
To set the cooking time, press the relevant time
value, e.g. hour display "h" or minute display "m".
a The selected value is marked in blue.
3.
Use the setting ring to set the cooking time.
If required, use
to reset the setting value.
4.
Use "End time" to set the time at which the opera-
tion should end.
→ "Setting the end time", Page 16
→ "Time-setting options", Page 15
5.
Place the food in the cooking compartment before
the appliance starts to heat.
6.
Press
to start the operation.
a The display shows the time remaining until the oper-
ation starts. The appliance is in standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
7.
When the operation has ended, remove the food
from the cooking compartment. The appliance auto-
matically switches off completely after approximately
15 to 20 minutes.
Note: If necessary, change the basic setting for the
lighting again.
4.
To confirm the set cooking time, press
play.
5.
Press
to start the operation.
a The appliance starts to heat and the time counts
down.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
6.
Once the cooking time has elapsed:
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Changing the cooking time
You can change the cooking time at any time.
1.
Press
on the display.
2.
Press the cooking time
3.
Use the setting ring to change the cooking time.
4.
To confirm the change, press
a The change is applied.
Cancelling the cooking time
You can cancel the cooking time at any time.
1.
Press
on the display.
2.
Press the cooking time
3.
Reset the cooking time using
Note: For operating modes that always require a
cooking time, the appliance resets the cooking time
to the preset value.
4.
To confirm the change, press
a The change is applied.
Time-setting options en
on the dis-
to switch the ap-
.
on the display.
.
.
on the display.
15