Bosch Evolution HES7152U 설치 지침 매뉴얼 - 페이지 15

{카테고리_이름} Bosch Evolution HES7152U에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Evolution HES7152U 48 페이지. Electric free-standing range

7) Complete the installation

• A risk of tip-over may exist if the appliance is not installed in accordance with

these instructions.

• If the range is pulled away from the wall for cleaning, service, or any other rea-

son, ensure that the Anti-Tip Device is properly reengaged when the range is

pushed back against the wall. In the event of abnormal usage (such as a person

standing, sitting, or leaning on an open door), failure to take this precaution could

result in tipping of the range. Personal injury might result from spilled hot liquids or

from the range itself.

1. Adjust height of range and level by rotating the adjustable leg supports on the

bottom of the range, using 1-1/4" (31.75 mm) wrench.

2. Measure to locate bracket position as shown below.

cabinet wall

3. Secure bracket with 2 screws adequate for mounting surface, not included.

(i.e.; for wood floor use wood screws for concrete floor use concrete anchors

and screws).

1. Move range close enough to the opening to plug into the receptacle.

2. Slide range into position ensuring that the left back leg slides under the anti-

tip bracket. Range will sit 3/4" (19.05 mm) away from back wall when properly

installed.

3. Carefully tip range forward to ensure that the anti tip bracket engages the

range back brace and prevents tip-over.

4. Turn on electrical power. Check range for proper operation as described in

Use and Care Manual.

drawer

wrench

adjustable leg

Adjusting the Leg Support

Figure 19:

rear wall

1 9/16" (39.7 mm)

from rear wall to center of screw hole

anti-tippin g

device

flush against

cabinet wall

Anti-tip Bracket Location

Figure 20:

floor

English 13