AirStage UTB-*V 운영 매뉴얼 - 페이지 2

{카테고리_이름} AirStage UTB-*V에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage UTB-*V 7 페이지. Air conditioner remote controller (wireless type)

페이지 인쇄
CONTENTS
SAFETY PRECAUTIONS.......................................................... 1
NAME OF PARTS ..................................................................... 1
PREPARATORY OPERATION ................................................... 2
OPERATION ............................................................................. 3

SAFETY PRECAUTIONS

G Before using the appliance, read these "PRECAUTIONS" thoroughly and operate in the correct way.
G The instructions in this section all relate to safety; be sure to maintain save operating conditions.
G "DANGER", "WARNING" and "CAUTION" have the following meanings in these instructions:
This mark indicates procedures which, if improperly performed, are most likely to result in the death of or serious injury to
the user or service personnel.
This mark indicates procedures which, if improperly performed, might lead to the death or serious injury of the user.
This mark indicates procedures which, if improperly performed, might possibly result in personal harm to the user, or
damage to property.
G Do not attempt to install this controller by yourself.
G This controller contains no user-serviceable parts. Al-
ways consult authorized service personnel for repairs.
G When moving, consult authorized service personnel
for disconnection and installation of the controller.
G If a problem (burning smell, etc.) occurs, turn off the
electrical breaker immediately to stop operation, and
then consult authorized service personnel.
G In the event of a malfunction (burning smell, etc.), im-
mediately stop operation, turn off the electrical breaker,
and consult authorized service personnel.
G Never place fingers or foreign objects inside the outlet
port. Doing so could cause personal injury.

NAME OF PARTS

4
Display
MASTER
SET
SET
FAN
CONTROL
TEMP. TIME
CONTROL
3
2
SET
SWING
SET
SWING
9
0
TIME ADJUST ACL
1
START/STOP
DANGER!
5
Display Panel
C
6
D
E
7
Rear side
A
8
SELECTING THE SIGNAL CODE ............................................. 4
OPERATING TIPS ..................................................................... 5
TROUBLESHOOTING .............................................................. 5
SPECIFICATIONS ..................................................................... 6
DANGER!
WARNING!
CAUTION!
G Do not expose the controller directly to water.
G Do not operate the controller with wet hands.
G Do not touch the switches with sharp objects.
G Always turn off the electrical breaker whenever clean-
ing the controller, the air conditioner or the air filter.
G Check the condition of the installation stand for damage.
G Ensure that any electronic equipment is at least one
metre away from the controller.
G Avoid installing the controller near a fireplace or other
heating apparatus.
G When installing the controller, take precautions to pre-
vent access to infants.
G Do not use inflammable gases near the controller.
G Take care to prevent infants from accidentally swal-
lowing batteries.
1 START/STOP button
2 Set temp./Set time buttons/Set code buttons
3 Master control button/Code change
4 Sleep timer button
5 Signal transmitter
F
6 Timer button
7 Fan control button
8 Battery compartment lid
9 Airflow direction button
G
0 Time adjust button
A ACL button
H
I
B Test run contacts
J
C Transmit indicator
D Clock display
E Master control display
B
F Timer mode display
G Fan speed display
H Set temperature display
I Timer set indicator
J Temperature set indicator
En-1
CAUTION!
Used when replacing batteries or change
the signal code.
Used when testing the air conditioner af-
ter installation.
*Do not use unless performing a test run.
Flashes while a signal is being transmitted
to the indoor unit.