AirStage UTY-CGG 운영 매뉴얼 - 페이지 6
{카테고리_이름} AirStage UTY-CGG에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage UTY-CGG 8 페이지. Air conditioner group remote controller (wired type)
페이지 인쇄WEEKLY TIMER
4
● Timer setting
Decrement Increment
5
● Operating setting
Raise
Lower
6
● Setting the next timer for the same day:
Then press the ENTER button to proceed to the time setting, and repeat steps from
● Repeat steps
Be careful for pressing the ENTER button without any operation setting because the time that is set will be
cancelled.
7
● Setting the timer for the other indoor units:
8
1. Press the ENTER button to confirm the set timer.
2. Press again the PROGRAM (CLOCK ADJUST)
button to complete the weekly timer setting.
*
flashes for two seconds.
● To delete the operating time
En-5
Press the Set Time buttons to set the time in 10-minute increments.
* Hold down a Set Time button to adjust the time quickly.
Press the Start/Stop button or the Mode button or the Set Temperature button to set
the operation.
* For the operations that can be set, refer to "Operation mode setting", "Room tem-
perature setting" (page 3), and "To start/stop operation" (page 4), in "OPERATION".
* Only the current operation settings are displayed.
AM
ex. TIMER-1 will start operation at 8:00 on COOL.
TIMER-1
3
5
to
to set the timer for another day of the week.
Before setting the timer for other indoor units, press the ENTER button to confirm the
settings.
* The display switches to the next timer.
● Repeat steps
CLOCK ADJUST
1. If the Timer Mode (DELETE) button is pressed during steps
ing time for the selected day will be deleted.
* If all the days are selected, the operating times for all of the days of the se-
lected timer will be deleted.
2. Press the ENTER button to confirm the deletion.
TIMER-2
2
6
to
to set the timer for other indoor units.
When the operating time is set, the
AM
ex. TIMER-1 will start operation at 8:00 on COOL with a set-
ting of 20 °C.
TIMER-3
TIMER-4
4
5
to
.
mark appears.
3
to
7
, the operat-