AirStage UTY-DCGG 설치 매뉴얼 - 페이지 6
{카테고리_이름} AirStage UTY-DCGG에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage UTY-DCGG 9 페이지. Central remote controller
AirStage UTY-DCGG에 대해서도 마찬가지입니다: 설치 매뉴얼 (11 페이지)
페이지 인쇄DIP Switch
No.
OFF
1
Disabled
Enabled
2
3
6. 4.
Installation Method - Integrated type
6. 4. 1
Integrated type
(1)
Pass power supply
cable through Hole-A, and connect it to the
power supply terminal of the power supply unit PC board.
(2)
Fix with the
cable tie.
Power supply cable
Cable tie (accessory)
(3)
Open the knockouts (2 places), and install the one touch bush (2
pcs, accessories).
(4)
Connect the connector of
relay connector of the cable coming from the power supply unit
PC board.
One touch bush (accessories)
knockout
Hole-B
Connection cable
(accessory)
knockout
Hole-C
One touch bush
(accessories)
(5)
Pass
Connection cable (accessory) through Hole-C and Hole-D,
and connect it to rear panel terminal.
En-5
Details
ON
For enabling/disabling the backup
function.
-
Not used. Fixed to "OFF".
-
Not used. Fixed to "OFF".
( :Factory setting)
Hole-A
POWER SUPPLY
L N
Power supply terminal
Connection cable (accessory) to the
Hole-A
Relay connector
(6)
Pass transmission cable through Hole-B, Hole-C, and Hole-D,
and connect it to rear panel terminal. Fix with the cable tie (ac-
cessory).
Transmission cable
Hole-B
Cable tie
(accessory)
Connection cable
(accessory)
Hole-C
Hole-D
(7)
Fix with the
cable tie (accessory).
Cable tie
(accessory)
Connection cable
Transmission cable
Rear panel terminal
Take care so that the earth (ground) cable does
not get into touch with other cables and parts.
(8)
Install the power supply unit to a wall. Then install the power sup-
ply unit cover and rear panel. Be careful not to pinch the cable.
Screw ×4
(9)
Connect the connection cable connector to the connector (CN13)
of the front panel PC board.
Hole-A
+5V
GND
X1
X2
Screw ×6
(accessories)