Bosch HB-58 Series 사용자 설명서 및 설치 지침 - 페이지 29
{카테고리_이름} Bosch HB-58 Series에 대한 사용자 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch HB-58 Series 40 페이지.
Bosch HB-58 Series에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지)
페이지 인쇄
Fault
Appliance is not heat-
ing, the colon flashes
in the display and a
appears.
The time flashes in
the display.
The time does not ap-
pear in the display
when the appliance is
switched off.
lights up in the dis-
play and no settings
can be made on the
appliance.
appears in the
display.
flashes in the dis-
play and the appli-
ance will not start.
appears in the
display.
A message with ap-
pears in the display,
e.g.
-
.
HomeConnect is not
working correctly.
20.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
Cause and troubleshooting
Demo mode is activated.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and back on again.
Deactivate demo mode within five minutes by changing the basic setting to .
2.
→ "Basic settings", Page 17
There has been a power cut.
Reset the time.
▶
→ "Setting the time on the clock", Page 12
The basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 17
Childproof lock is activated.
Use the
button to deactivate the childproof lock.
▶
→ "Childproof lock", Page 17
Cleaning recommendation
Run the cleaning function in full.
▶
→ "EcoClean ", Page 22
You can temporarily dismiss the information in the display by pressing any button.
→ "Cleaning recommendation", Page 22
The cooking compartment is too hot for the selected operation.
Switch off the appliance and allow it to cool down.
1.
Restart the operation.
2.
The maximum cooking time has been reached. To prevent an unwanted permanent opera-
tion, the appliance automatically stops heating after several hours if the settings are un-
changed.
Switch off the appliance.
▶
You can configure new settings if required.
Tip: To prevent the appliance from switching off when you do not want it to, e.g. for an
extremely long preparation time, set a cooking time.
→ "Time-setting options", Page 11
Electronics fault
Press the
button.
1.
If required, reset the time.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. Quote the exact error
2.
message and the E no. of your appliance.
→ "Customer Service", Page 30
Different causes are possible.
Go to www.home-connect.com.
▶
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
Place a tea towel in the cooking compartment to
1.
prevent damage.
Turn the glass cover anti-clockwise to remove it .
2.
Troubleshooting en
29