AirStage UTY-LNH series 운영 매뉴얼 - 페이지 11
{카테고리_이름} AirStage UTY-LNH series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage UTY-LNH series 16 페이지. Air conditioner remote controller wireless type
AirStage UTY-LNH series에 대해서도 마찬가지입니다: 운영 매뉴얼 (15 페이지)
페이지 인쇄SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE
When two or more air conditioners are installed in a room and the remote control unit is operating an air conditioner other
than the one you wish to set, change the signal code of the remote control unit to operate only the air conditioner you wish to
set (four selections possible).
When two or more air conditioners are installed in a room, please contact authorized service personnel to set the individual air
conditioner signal codes.
Selecting the Remote Control Unit Signal Code
Use the following steps to select the signal code of the remote control unit. (Note
that the air conditioner cannot receive a signal code if the air conditioner has not
been set for the signal code.)
1
Press the START/STOP button until only the clock is
displayed on the remote control unit display.
2
Press the MODE button for at least five seconds to dis-
play the current signal code (initially set to ).
3
Press the SET TEMP. (
signal code between
display to the air conditioner signal code.
4
Press the MODE button again to return to the clock
display. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock
display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact authorized service personnel to change the signal code.
The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a
signal code other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
code which operates the air conditioner.
/
) buttons to change the
. Match the code on the
) until you find the
En-10