AirStage UTY-LNH series 운영 매뉴얼 - 페이지 6
{카테고리_이름} AirStage UTY-LNH series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage UTY-LNH series 16 페이지. Air conditioner remote controller wireless type
AirStage UTY-LNH series에 대해서도 마찬가지입니다: 운영 매뉴얼 (15 페이지)
페이지 인쇄OPERATION
To Select Mode Operation
1
Press the START/STOP button.
The receiver unit control panel's OPERATION Indicator Lamp (green) will
light.
The air conditioner will start operating.
2
Press the MODE button to select the desired mode.
Each time the button is pressed, the mode will change in the following
order.
s
AUTO
HEAT
About three seconds later, the entire display will reappear.
*1 "AUTO" can be set only in the indoor unit assigned to the repre
sentative indoor unit.
*2 "FAN" cannot set to heat pump type.
To Set the Room temperature
Press the SET TEMP. button.
button: Press to raise the thermostat setting.
button: Press to lower the thermostat setting.
G Thermostat setting range:
AUTO .................................. 18-30 °C
Heating ............................... 16-30 °C
Cooling/Dry ........................ 18-30 °C
The thermostat cannot be used to set room temperature during the FAN mode (the
temperature will not appear on the Remote Control Unit's Display).
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN button.
Each time the button is pressed, the fan speed changes in the following order:
s
s
AUTO
About three seconds later, the entire display will reappear.
When set to AUTO:
Heating: Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the temperature
of the air issued from the indoor unit is low.
Cooling: As the room temperature approaches that of the thermostat setting,
the fan speed becomes slower.
Fan:
The fan runs at the low fan speed.
The fan will operate at a very low setting during Monitor operation and at the start
of the Heating mode.
En-5
*1
s
COOL
s
DRY
*2
t
FAN
t
s
s
HIGH
MED
LOW
Example: When set to COOL.
Example: When set to 26 °C.
Example: When set to AUTO.