Electrolux 137064300 B 설치 지침 매뉴얼 - 페이지 13

{카테고리_이름} Electrolux 137064300 B에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 137064300 B 20 페이지. Electrolux front-load washer installation instructions

페이지 인쇄

Preparing to reverse door swing

1 Be sure you have adequate swing area before reversing door.

2 You will need a screw driver with a #2 square bit.

3 Protect flat work surface, such as top of washer or floor near

washer, with a soft cloth or towel.

4 Be sure washer is unplugged from power source!

Failure to disconnect power source before servicing

could result in personal injury or even death.

Removing door and hardware

A) Removing Trim Ring

1 Open the door to a 90 degree angle.

2 Remove and save the trim plug and long,

course-thread, panhead screw.

3 Close the door.

4 Rotate the door trim approximately ¾"

counter-clockwise and pull it away from the

front of the door.

WARNING

ELECTRICAL SHOCK HAZARD

Reversing Door

B) Removing Door from Hinge

1 Reopen door to 90 degree angle.

2 Remove 4 long, course-thread, counter-sunk

hinge screws from door.

3 While supporting the weight of the door

with both hands, separate the door from the

hinge.

4 Gently place the door face down on a flat,

covered work surface.

Tools needed:

Screwdrivers with

#2 square &

straight bit