Electrolux 400 SERIES 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} Electrolux 400 SERIES에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 400 SERIES 50 페이지. Front load dryer
Electrolux 400 SERIES에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (16 페이지), 사용 및 관리 매뉴얼 (39 페이지), 사용 및 관리 매뉴얼 (28 페이지), 사용 및 관리 매뉴얼 (46 페이지)

페이지 인쇄

5. Tighten by hand

until snug. Then

tighten each

supply connec-

tion another 2/3

turn with pliers.

Do not bend, kink or pinch water

inlet hoses.

6. Turn on the water

and check for

leaks.

Connecting drain and

electrical

1. Verify the

anti-siphon

disc is

in place.

2. Form a "U"

shape on

the end of

the drain

hose with

the hose pointed toward the drain.

Place the formed end in a laundry tub

or a standpipe and secure the drain

hose with the cable tie (provided in the

enclosure package) to the standpipe,

inlet hose, laundry tub, etc. so the hose

does not pull out from the force of the

water.

Cable Tie

Installation Instructions

Anti-Siphon Disc

Insert Less

Than 8.5"

(21.5 cm)

NOTE

The standpipe inside diameter must be

1-1/4" (3.2 cm) minimum. There must be

an air gap around the drain hose in the

standpipe. A snug hose fit can cause a

siphoning action.

IMPORTANT

Check to ensure the power is off at a

circuit breaker/fuse box before plugging

the power cord into an outlet.

3. Plug the power cord into a grounded

outlet.

WARNING

ELECTRICAL SHOCK HAZARD

Improper connection of the equipment

grounding conductor can cause an elec-

trical shock that may result in serious inju-

ry or death. Check with a licensed electri-

cian if you are in doubt as to whether the

appliance is properly grounded.

See Electrical System Requirements and

Grounding Requirements sections of this

instruction for additional information.

4. Turn on the power at a circuit breaker/

fuse box.

5. Carefully slide the washer to its final

position. Recheck for level and rock

corners for stability. See "Leveling

your washer" section. Remove and

discard door tape.

6. Read the Use & Care Guide provided

with the washer. It contains valuable

and helpful information that will save

you time and money.

7. Run the washer through a complete

cycle, checking for water leaks and

proper operation.

8. If you have any questions during initial

operation, please review the "Service

Prevention Checklist" in your Use &

Care Guide before calling for service.

9. Place these instructions in a location

near the washer for future reference.

NOTE

A wiring diagram and technical data

sheet are located under the washer top

panel, on top of the detergent dispenser

housing.