Electrolux 400 SERIES 설치 지침 매뉴얼 - 페이지 14

{카테고리_이름} Electrolux 400 SERIES에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 400 SERIES 50 페이지. Front load dryer
Electrolux 400 SERIES에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (16 페이지), 사용 및 관리 매뉴얼 (39 페이지), 사용 및 관리 매뉴얼 (28 페이지), 사용 및 관리 매뉴얼 (46 페이지)

14 Reversing Door

Reversing Door Assembly, continued

3. Make sure the alignment tabs reengage.

Connect to Notches

4. Reattach the inner door to the outer

door using the nine screws removed

earlier. See illustration, Step 1.

5. Check to verify that the

scoop (wider section) of

the door glass is situated

at the BOTTOM of the

door.

Reinstalling Door Assembly

1. Insert the wiring harness terminal into

the terminal cap and wrap the harness

into the harness retainer.

2. Slide terminal cap onto back of hinge

plate until tabs snap into place.

3. Insert hinge locating pins into the hole

that were previously covered by the

plastic hole cover. Press on the face

of the hinge to snap the other locating

pins into place.

4. Reinstall all four screws removed

earlier - two front screws first, then two

side screws.

Fine Thread

Verify Reversed Door Operation

1. Test door for free, smooth swinging

operation and secure latching when

closed.

2. Verify inner door glass is in the correct

orientation with the "scoop" at the

bottom.

3. Plug in washer and close the door.

Test correct door lock operation by

starting a test cycle: lock should

engage, and door should not be able

to be opened until cycle is paused or

canceled.