Electrolux 500 SERIES 사용 및 관리 매뉴얼 - 페이지 22

{카테고리_이름} Electrolux 500 SERIES에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 500 SERIES 46 페이지. Front load dryer
Electrolux 500 SERIES에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (39 페이지), 설치 지침 매뉴얼 (50 페이지), 사용 및 관리 매뉴얼 (28 페이지)

페이지 인쇄

Installation

Rubber Washer

Must be Present

and Undamaged

3. Turn on COLD supply and run water to

clear any contaminants in the line.

4. Inspect hose couplings for proper

placement of rubber washers. Use

hoses from ASSEMBLY HOSE KIT#

5304495002 (not included).

5. If your installation has room for the

COLD water supply to accept the

"Y" connector directly, thread the "Y"

connector to the COLD water supply

and snug it by hand; then tighten it

another 2/3 turn with pliers.

NOTE

If you were able to install the "Y"

connector directly to the COLD water

supply, please skip to step 8.

Cold Inlet Hose

to Washer

Rubber Washers

MUST BE PRESENT

Short Hose

"Y" Connector

Cold Water Supply

Hose to Washer

6. If there is not room to install the "Y"

connector directly, thread the short

extension hose on to the COLD water

supply and snug it by hand; then

tighten it another 2/3 turn with pliers.

7. Thread the "Y" connector to the short

extension hose and snug it by hand;

then tighten it another 2/3 turn with

pliers.

8. Connect the COLD inlet hose for the

washer to the "Y" connector and snug

it by hand; then tighten it another 2/3

turn with pliers.

9. Connect the straight end of the long

hose from the kit to the other outlet

on the "Y" connector and snug it by

hand. Connect the hose's 90° coupling

to the brass water inlet on the back of

the dryer and snug it by hand. Tighten

each connection of the dryer inlet hose

another 2/3 turn with pliers.

10. Turn on the water and check for leaks

at all connections.

Water Inlet

on Dryer