Electrolux 600 SERIES 사용 및 관리 매뉴얼 - 페이지 35

{카테고리_이름} Electrolux 600 SERIES에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 600 SERIES 39 페이지. Front load dryer
Electrolux 600 SERIES에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (50 페이지), 사용 및 관리 매뉴얼 (28 페이지), 사용 및 관리 매뉴얼 (46 페이지)

페이지 인쇄

OCCURRENCE POSSIBLE CAUSE

Warm or hot wa-

• Hot water heater is set too

ter is not hot

enough

• Hot water is being used

Water in washer

• Drain hose is kinked or

does not drain or

drains slowly

• Drain hose standpipe is too

• House drain pipes are

Water leaks

• Fill hose connection is loose

• Dispenser drawer not com-

• Water hoses have damage,

Oversudsing

• HE detergent is not being

• Too much detergent.

Incorrect wash

• Hot and cold water hoses

and rinse tem-

peratures. The

LED display will

alert this condi-

tion with "HOSE"

alarm

Water is entering

• Drain hose standpipe is too

washer but tub

does not fill

low or is a distance from

washer.

elsewhere in the house.

clogged.

tall. Maximum standpipe

height is 8' (2.4 m).

clogged.

at faucet or washer.

pletely closed

cuts or corrosion.

used.

are connected to wrong

supply faucets.

low. Standpipe must be a

min of 23.6" (60 cm) high to

prevent siphoning.

Before Calling

SOLUTION

• Measure hot water temperature at

nearby faucet with candy or meat

thermometer. Water temperature

should be at least 120°F (49°C).

Adjust water heater as necessary.

• Avoid using hot water elsewhere

before or during washer use. There

may not be enough hot water avail-

able for proper cleaning. If problem

persists, your hot water system

may be unable to support more

than 1 use at a time.

• Clean and straighten the drain

hose.

• Reduce standpipe height to less

than 8' (2.4 m). See Installation

Instructions .

• Unclog drain pipes. Contact

plumber if necessary.

• Check and tighten hose connec-

tions. Install rubber sealing washers

provided.

• Close dispenser drawer completely.

• Replace hoses.

• Run rinse cycle. Use a low-sudsing,

high efficiency detergent.

• Run rinse cycle. Use less detergent

in future loads.

• Connect hot water hose to hot

water faucet and cold water hose

to cold water faucet.

• Increase standpipe height to at

least 23.6" (60 cm). See Installation

Instructions .