Electrolux 600 SERIES 설치 지침 매뉴얼 - 페이지 13

{카테고리_이름} Electrolux 600 SERIES에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 600 SERIES 50 페이지. Front load dryer
Electrolux 600 SERIES에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (39 페이지), 사용 및 관리 매뉴얼 (28 페이지), 사용 및 관리 매뉴얼 (46 페이지)

페이지 인쇄

Removing Door Assembly, continued

6. Release wiring harness from retainer

on plastic terminal cap. Then release

terminal from terminal cap. Save the

cap to reinstall later.

Removing Door Lock and Plas-

tic Hole Cover

1. Locate and remove both screws from

door lock. Save screws for later.

2. Rotate the lock as you pull it out

through the front panel. Take care not

to pull too hard or too far as the lock is

still attached to the wiring harness.

Coarse

Thread

3. Disconnect the wiring harness terminal

from the door lock. Set the door lock

aside for reinstallation later.

4. Pry the bottom of the plastic hole cover

upward to release it from the front

panel. You may have to use a non-

scratching plastic knife if you are un-

able to release it manually. Then, slide

the cover down slightly and remove it

from the front panel.

Front

Panel

Reversing Door

Reinstalling Door Lock and Hole

Cover

1. Move the plastic cover to the other side

of the front panel. Position the cover so

the "hook" is at the bottom. Insert hook

into lower slot, slide the cover down,

and press upper retention tabs into

opening until they snap into place.

2. Insert wiring harness into door lock.

3. Insert door lock into front panel and

reinstall door lock screws.

Coarse

Thread

Reversing Door Assembly

1. Locate nine screws on inner door ring.

Remove each and save for reinstal-

lation later. Remove inner door (with

hinge) and carefully set aside.

2. Lift door glass slightly and rotate 180

degrees, setting it back onto outer door.

180