Electrolux 913128348 사용자 설명서 - 페이지 10
{카테고리_이름} Electrolux 913128348에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 913128348 36 페이지.
페이지 인쇄
10
www.electrolux.com
• Activate the Night
The intermediate and the final
spinning phases are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
The display shows the indicator
The lid stays locked. The drum turns
regularly to reduce creasing. You
must drain the water to unlock the lid.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
If you touch the Start/Pause
button, the appliance performs the
only draining phase.
The appliance empties
the water out
automatically after 18
hours approximately.
5.5 Prewash
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the
touch button illuminates.
• Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust, mud and other
solid particles.
The options can increase the
programme duration.
5.6 Stain
Touch this button to add the stain phase
to a programme.
The corresponding indicator above the
touch button illuminates.
Use this option for laundry with hard
stains to remove.
When you set this option, put the stain
remover into compartment
option.
.
.
The stain remover is pre-mixed and
heated with detergent in order to improve
its effectiveness.
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
5.7 Permanent Extra Rinse
With this option you can add a few rinses
according to the selected washing
programme.
Use this option for people with allergies
to detergent residues and with sensitive
skin.
This option increases the
programme duration.
The corresponding indicator above the
touch button illuminates and also stays
permanently on during next cycles until
this option is deactivated.
5.8 Permanent Soft Plus
Set this option to optimise the fabric
softener distribution and improve fabric
softness.
Recommended when you use fabric
softener.
This option increases the
programme duration.
The corresponding indicator above the
touch button illuminates and also stays
permanently on during next cycles until
this option is deactivated.
5.9 Steam Finish
Touch this button to set the steam level.
This is possible only with programmes
where the steam function is available.
The duration of the steam phase
changes accordingly to your selection.
5.10 Delay Start
With this option you can delay the start of
a programme to a more convenient time.