AirStage UTY-RLRY 운영 매뉴얼 - 페이지 3

{카테고리_이름} AirStage UTY-RLRY에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage UTY-RLRY 11 페이지. Wired remote controller

페이지 인쇄

■ SYSTEM OUTLINE

Terminology

System related terms

(a) Heat recovery system:

The indoor unit connects to the outdoor unit via an RB

unit (Refrigerant Branch unit) in this system. RB units

of single type and 4-system multi type are available .

Indoor units connected to RB units of a different system

perform cooling operation and heating operation simul-

taneously. An indoor unit connected to an outdoor unit

without going through an RB unit are for cooling only.

(b) Heat pump system:

This is standard system. Indoor units connected to the

same outdoor unit do not perform cooling operation and

heating operation simultaneously.

A group of indoor units connected to a single type RB

unit or each system of a multi type RB unit. Cooling op-

eration and heating operation are not performed simul-

taneously in an RB Group.

(d) R.C. Group (Remote Controller Group):

This forms a group by connecting indoor units by remote

controller cable. Each 1 unit of ungrouped indoor unit

makes up an R.C. Group. It is the minimum unit of op-

eration.

(e) Refrigeration system:

This is a system composed of indoor units and outdoor

units connected by the same refrigerant piping.

(f)

System:

This is 1, 2 or more Refrigerant Systems connected by

the same transmission cable.

(g) Central controller:

A central remote controller can control the multiple R.C.

Groups. There is a System Controller, Touch Panel Con-

troller, and a Central Remote Controller.

(h) Standard remote controller:

A standard remote controller is a remote controller

which controls 1 R.C. group. This unit corresponds to

this. This unit cannot be used together with a 3-wire

type Wired Remote Controller. A Wireless Remote Con-

troller can be used together with this unit.

Address related terms

(i)

Refrigerant circuit address:

This is the ID individually assigned to each refrigerant

system and is used for control.

(j)

Indoor unit address:

This is an ID individually assigned to each indoor unit.

(k) Remote controller address:

This is an ID individually assigned separately from the

indoor unit address to indoor units which form an R.C.

Group.

(l)

2-wire remote controller address:

This ID is used for control and is allotted to remote

controllers in R.C. Group formed by 2-wire type remote

controllers and indoor units. The ID consists of 3-digit

"System number" and 2-digit "Unit number".

IDs are automatically assigned if the remote controller

address of all indoor units in the R.C. Group are set to "0".

(m) System number:

Indicates types of unit in R.C. Group formed by 2-wire

type remote controllers.

001: Remote controller, 002: Indoor unit

(n) Unit number:

This number allotted to individual units in R.C. Group

formed by 2-wire type remote controllers. If 2-wire

remote controller address is set manually, numbers that

duplicate remote controller addresses in R.C. Group

cannot be used.

En-2